The new PLASSON MCP (meter connection point) provides mains isolation, meter connection, drain point and back flow prevention in a compact one piece unit. for single meter connection MCP
KEY FEATURES Monobloc design for quick and easy installation Quarter turn high flow mains stop valve 1 1/2” Class D concentric meter connection Approved double check valve built in Built in drain point NBR & EPDM sealing for water tight integrity Kiwa UK Regulation 4 (KUKreg4) approved
UUW 15mm & 20mm Meter Location Policy: Internal Meter Installation
Tel 01444 244446
sales@plasson.co.uk
www.plasson.co.uk
MCP
Technical Specification
Double check valve
Drain Cap
Meter seat Plug
Valve Handle
H
L
W
Product Codes
Code
Description
L
H
W
PM0351071025015 PM0351071025022 PM0351021025022 PM0351071022022 PM0351071028028
MCP 25mm PE x 15mm Cu/PB/PEX MCP 25mm PE x 22mm Cu/PB/PEX MCP 25mm Barrier x 22mm Cu/PB/PEX MCP 22mm Cu/PB/PEX x 22mm Cu/PB/PEX MCP 28mm Cu/PB/PEX x 28mm Cu/PB/PEX
280 280 280 275 275
130 130 130 130 130
80 80 80 80 80
Other inlet and outlet connections are available. Please contact your PLASSON ASM for details.
Specification
A UK Water Regulation 4 approved one piece meter carrier consisting of, in the following sequence: quarter turn mains isolation valve, connection point for Class D water meter, serviceable double check valve (ED suitable for fluid category 3) and drain point. Unit with 1” ISO 228 threads to allow connection of PLASSON fittings for various pipe connections.
Technical Details: Maximum Operating Pressure
Water PN16
Water Meter Connection
DN40 internal thread
Maximum Operating Temperature
23°C
Material
High grade polypropylene copolymer body, EPDM ‘O’ rings and seal
Note: The MCP unit has ‘O’ rings on the male threads that seal only the special PLASSON mechanical and pushfit fittings supplied with the MCP, these require no additional sealing materials which could compromise the ‘O’ ring seal. To install the PLASSON fitting onto the thread, engage the threads and screw the fitting on firmly by hand. The 1” x 3/4” meter union, seals with flat washers supplied, wrench tighten. The meter seat plug is for initial testing but is also suitable for long term use if required. It is ‘O’ ring sealed, if removed to fit a meter, please also remove the seal and use the seals supplied with the meter. It is a full-flow plug.
Tel 01444 244446
sales@plasson.co.uk
www.plasson.co.uk
Page 1 Page 2Powered by FlippingBook