ElectroFusion Welding
Once all required tooling and parts are ready following the previously described actions we are ready to begin with the welding process.
Before starting the actual weld, there are a few steps that should be followed: • Make sure that the power generator fuel tank is full in order to eliminate the chance of the welding process stopping prematurely (before the required weld time has been completed). This step is most important with large diameter fittings where the weld times may be much longer than in small fittings. • Start up the power generator and wait until the voltage output is stable - we do not want to start work with unstable power input into the controller. • Once the voltage is stable connect the control box to the power generator. • Connect the terminals to the fitting.
Full assembly ready for welding
18
Powered by FlippingBook